You can purchase the whole kit or just the parts you need. Note: you will need to remove both ends of the boom to install. The small wire pennant is crimp swaged to the Harken 227 double micro with becket and the other end has a crimp swage eye with thimble that will be attached to the through bolt(inside the end casing) attaching the boom end to the gooseneck. The other wire pennant is crimp swaged to the Harken 228 triple micro while the other end is left unfinished. The unfinished end must be run through the outboard end boom fitting prior to crimp swaging on the clew shackle. So, be prepared, you will need to nicropress the clew shackle to the wire during installation (oval sleeve and thimble included). We assume you will be using your existing clam cleat mounted on the underside of the boom and the clew shackle. The H228 bullet swivel block with shackle is attached to the boom vang plate on the underside of your boom. The photo above is only representative. Wire and line lengths are longer than pictured.

Kit includes

• H228 Micro Triple
  
• H227 Micro Double with Becket
  
• 1/8” Wire Pennant attached to H227 with Crimp/Thimble eye on the other end
  
• 1/8” Wire Pennant attached to H228 and an unfinished end
  
• Oval sleeve, thimble & a Wichard D shackle
  
• Marlow Super PreStretch line
  
• H228 Bullet Swivel Block
  
• Wichard WC1403 Clew Shackle
  
• Clam Cleat not included