|
|
||||||||
APS Spinnaker Launching Bag: Pro |
||||||||
|
Spinnaker Launching Bag: Pro Measures: Fore and aft: 25" Side to side: 25" Depth: 30" All mesh design. We made this nice and deep so you can stuff the spinnaker down and it does not start to blow back out. Slight taper at the bottom. Battens on all four sides of the opening, a Velcro halyard keeper strap. Large race instruction pouch/window with Dacron backing to keep a wet spinnaker from getting papers wet. Has slots inside the pocket for pencils/pens. Two side mesh pockets with Velcro flaps securely keeps your VHF safe and within reach. Spring loaded durable bronze hanks. (not included, try small 1/8" Amsteel Blue. It's slippery and allows the bag to easily slide).
|
|||||||
|
||||||||
View larger
|
|
|||
APS Spinnaker Launching Bag: Basic |
|||
 |
Spinnaker Launching Bag: Basic Measures: Fore and Aft: 25" Side to Side: 30" Depth: 18" We've tweaked our always-popular Spinnaker Launching Bag to make it even better! It's now larger and has battens on all four sides of the opening, a Velcro halyard keeper strap, and a larger race instructions pouch in addition to the full mesh bottom for drainage. Designed to ride on two taught, low-stretch line "rails" (not included, try small 1/8" Ultrex 12 (Sold by the foot). It's slippery and allows the bag to easily slide). Comes in assorted colors. |
||
|
|||
|
|
||||||||||||||||||||||||||||||||
 |
||||||||||||||||||||||||||||||||
Lifting Straps |
||||||||||||||||||||||||||||||||
These webbing straps are great for hoisting/launching the J/80. They are constructed of a durable, 2-Ply material, which features the strap's load rating sewn near one of the loops for safety. Both ends are covered with a chafe-resistant material to increase the durability of the loop at the connection point. The wide shackle fits under the lifting bar on the keel.
|
||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||
|
|
||||||||
Rub Strakes by Sea Dog |
||||||||
 |
Protect your gel coat with the Sea Dog Rub Strake. Made of stainless steel, it's easy mounted to prevent chafing on your deck. No more unnecessary wear and tear from sheets and furling lines.
Rub Strakes 8" x 3/4" or 12" x 3/4"
|
|||||||
|
||||||||
|
|
|||
Spinnaker Halyard Clip by SOAK |
|||
 |
SOAK Halyard Clip Designed for Boats up to 40' Designed to prevent accidental spinnaker launches when sailing upwind and to keep the halyard from fouling during tacks. Plus, it automatically release when you're hoisting, so it's one less than to worry about going around the top mark. Made of high quality Nylon with UV inhibitor for durability. Nylon attachment line included. Works best with lines from 5/32 (4mm) to 3/8 (9mm). We have found that it works best with stripped line because covered line is too rigid. For covered line we only recommend it up to 5/16". |
||
|
|||
|
|
||||||||
Vinyl Rigging Tape |
||||||||
 |
From securing ring dings and pins to holding blistered hands together for one more race, just about anyone who ever sails uses this stuff by the mile. Economy or Standard we offer two grades of this UL listed, white electrical, er...rigging tape. Both are 7mm thick, 3/4 of an inch wide and 66 feet long in white. So, why do we offer both?
The Economy has a slightly less agressive adhesive and a little less stretch, but a really attractive price. If you travel a lot with your boat burning through roll after roll every weekend when you rig and de-rig your boat this is perfect for you. The Standard offers a bit more agressive adhesive on a more durable vinyl for improved holding power and stretch. It even comes with a handy dandy carrying case. This is the stuff to use if you are a set it and forget it type sailor who steps their rig once and year and rarely re-tapes things. |
|||||||
|
||||||||
|
|
||||||||
Loos Professional Tension Gauge |
||||||||
 |
Tension Gauge An inexpensive yet accurate method of checking the tension of your standing rigging. Manufactured of rugged anodized aluminum, this gauge is corrosive resistant and will give years of service. Detailed operating instructions are included with each tension gauge. Higher accuracy and easier to use than standard models. The cable can be adjusted while the gauge remains on the cable. "Just watch the pointer move." All readings are based on 302/304 1x19 S.S breaking strengths. Available for standard or metric rigging. Offers improved accuracy and durability. Easier to use. LSPT-1 is for 3/32 to 5/32 inch wire LSPT-2 is for 3/16 to 1/4 inch wire |
|||||||
|
||||||||
|
|
||||||||
Loos Standard Tension Gauge |
||||||||
 |
Standard Tension Gauge The Loos economy tension gauge takes the guesswork out of cable tension adjustment. It's especially designed for accurate, repeatable tuning of a sailboat's standing rigging. Manufactured of rugged anodized aluminum, the gauge is corrosion-resistant and will provide years of service. The LS91 is small and is used on 3/32 to 5/32 inch wire; the LS90 is large and is used on 3/16 to 9/32 inch wire. |
|||||||
|
||||||||
|
|
|||||||
 |
|||||||
APS Sheet Bags |
|||||||
| Made of heavy marine mesh in front with Dacron backs and shock cord in the hem to hold them shut. Installed grommets allow for permanent installation with screws. These are built to be used hard. |
|||||||
|
|
|
|||
Motor Mount by Hall |
|||
 |
This super stiff Motor Mount is strong but remains lightweight. Made with a lightweight welded aluminum base with UHMW (polyethelyene) support. Weighs 2.7 lbs. Hole spacing: 3-3/4 in. Length to inboard edge of bracket: 6-3/4". length to outboard edge of bracket: 8-1/4". Thickness: 1-1/2". Top Length: 5-1/2". |
||
|
|||
|
|
|||||||
 |
|||||||
TackTick Micronet Race Master |
|||||||
The next generation of TackTick's popular Master Series, the Micronet Race Master comes loaded with user and installation friendly features. Its two-tier display shows your heading, how far you are above or below the mean course, and how much you are being headed or lifted. It will enable you to establish quickly and easily which is the favored end of the start line, and will help you sail the shortest distance to the windward mark. Downwind, you can see how far off dead downwind you are, and when you should gybe for optimal VMG. The Race Master is a wireless device, so there are no wires to run or connections to make during installation. It also features three level backlighting, a battery level indicator, waterproofing up to 10m (~33 ft.) and a lightweight (1.0 lbs), shock resistant display with super-large digits for easy viewing anywhere on your boat. The unit will display the following data: compass heading, wind shifts, line bias and a race timer. The system can then be further extended to allow the addition of Boat Speed, Depth, Wind and GPS information as well as compatibility with the complete range of Micronet Displays. With the multitude of options that are available with the Micronet system, you can create your own personalized system with ease. Also available is the Race Master System, which offers you all of the benefits of the Race Master but also includes the Micronet Hull Triducer (provides temperature, boat speed and depth data), Hull Transmitter (for Triducer) and Solar Panel (for Hull Transmitter). |
|||||||
|
|
|
|||||||||||||||
Davis Windex 10 Sport |
|||||||||||||||
 |
The secret of the Windex Sport Vane is in the sapphire jewel suspension bearing, large fin-low inertia vane, and easy-to-read, fully adjustable tacking tab system.
Reflector tape on the vane and tacking tabs make Windex 10.Sport easy to see day and night. Windex vanes are sturdy and when installed properly, offer many years of use. They have been wind tunnel tested to wind speeds of 80 knots! Windex 10.Sport has a 10" (25 cm) vane. Includes glass reinforced polycarbonate J-Base for side, top or front of mast mounting on most dinghies, smaller boats and sport boats. Stands just 9.25" (23.5 cm) tall and weighs 1.2 ounces (31 g). Replacement vane (sold separately) also available. |
||||||||||||||
|
|||||||||||||||
|
|
||||||||
Mastboot Tape |
||||||||
 |
Mastboot tape is a self-bonding rubber that welds to itself by chemical action to form a waterproof covering. This tape conforms to irregular surfaces, and in most cases does not require un-stepping the mast - cuts easily with scissors for easy installation. Mastboot has a very good UV resistance and will last years in the sun; canvas or acrylic cover recommended for chafe protection.
Available in two lengths - for boats up to 40', and for boats up to 60'. Comes with instructions for installation. |
|||||||
|
||||||||
