Dry Suit Replacement 3D Sock Seal MD (1)
|Neck Seal||Wrist/Cuff Seal||Ankle Seal||Flat Sock Seal||3D Sock Seal|
|Diameter (A)||Diameter (A)||Diameter (B)||Diameter (A)||Diameter (A)||Diameter (A)||Diameter (B)|
*Size Tolerance on all itmes: +/- 2.5%
This 3D Drysuit Replacement Socks Seal has the benefit of an articulated design for added comfort. The shape allows for less bunching when worn with socks and dinghy boots.
Designed for fitting to dry suits with 200mm (7.9”) flat width trouser opening. To create a 180mm (7.1”) flat width seal, cut off the top 60mm of the seal (line show in the illustration).
Seals are made with 100% percent latex rubber. Home installation is accomplished using Aquaseal adhesive which dries in 24 hours. The addition of Cotol-240 speeds up full cure time of Aquaseal to 2 hours. Adhesives sold separately.
We sell dry suit seals for home installation only. Installing all five seals (neck, wrists and booties) will usually consume two tubes of Aquaseal.
- Size: Medium
- 100% latex rubber
- Sold individually]
- 3D Design for added comfort
If you require exact seal sizing, refer to the illustration above when using these measurements:
Size Length 'A' Length 'B' Small 230mm 195mm Medium 250mm 300mm Large 270mm 305mm
|Recommended Use||Cold Weather|