Dry Suit Replacement Conical Wrist Seals
These Dry Suit Replacement Wrist Seals are available in two sizes. Seals are sold individually.
Seals are made with 100% latex rubber. Home installation is accomplished using Aquaseal adhesive which dries in 24 hours. The addition of Cotol-240 speeds up full cure time of Aquaseal to 2 hours. Adhesives sold separately. Installing all five seals (neck, wrists and booties) will usually consume two tubes of Aquaseal.
These seals can be stretched if they are slightly too tight. Because these are available in only two sizes, it is common to have to size them by cutting these tapered seals along the ‘trim ‘lines’ molded into the seals. Each ring that is cut away enlarges the seal opening.
- 100% latex rubber
Refer to the illustration above when using these measurements. The diameter is measured with the suit opening perfectly round (not lying flat).
- Small: 36mm (1.42")
- Large: 40mm (1.57")
|Material / Fabric||100% Latex Rubber|