Complete cockpit bailer assembly for the Sunfish. Includes plug and cap, O-ring, bailer housing and bailer ball.
This bailer suits Sunfish built before 1972. Has a 1-5/16 in long threaded cap.
This is the topside half of the bailer assembly for pre-1972 sunfish.
Prior to 1972, the Sunfish had a slightly thicker hull between the floor of the cockpit and the exterior of the boat. New sunfish bailers are not long enough for the two halves to connect.
This plastic Sunfish bailer cap fits into cockpit. It is threaded to screw into the bailer housing (sold separately).
If you are looking for a complete auto bailer check out LP91026.
O-rings for your V15 bailer. Sold in a package of 5 so you will have plenty of extras on hand.
The bailer ball sits inside the housing of the Sunfish bailer. This replacement is a pack of five, includes rubber gasket.
This part is just one component to the Sunfish bailer. Under the cockpit on the bottom of the boat sits this bailer housing containing a ball inside.
For the complete bailer kit see LP91026.
EMAIL US 800-729-9767